Thursday, 12 September 2013

Installing Jacking Point Rubber

I ordered these a while ago but didn't have time to install them till today. It's a simple process and it took no more than a few minutes for all 4 corners.
For those who need them, the part number is 2019970086 and it cost me about $10 each here in Australia.

Here they are in all their new, clean and shiny glory.

Spray a bit of lubricant on the part that's inserted into the chassis.

Place it on a scissor jack and wind it up

Initially, it'll lift the car, but then the weight of the car pushes the rubber into the plug hole. All done.

This is one of the easiest and cheapest things you can do.

No comments:

Post a Comment